Display Assembly; Removing The Display Assembly - Dell Inspiron 1545 Service manual Service Manual

Back to Contents Page
Display
Dell™ Inspiron™ 1545 Service Manual
Display Assembly
Display Bezel
Display Panel
Display Panel Cable
Display Inverter
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE: To help prevent damage to the system board, remove the main battery (see
computer.
NOTICE: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not
covered by your warranty.
Display Assembly

Removing the Display Assembly

NOTE: The location of the Mini-Card may change according to the display adapter supported by your computer. To find the type of display adapter on
your computer, click Start® Control Panel® System® Device Manager® Display adapters.
1. Follow the instructions in Before You
2. Remove the center control cover (see
3. Remove the base cover (see
4. Disconnect the Mini-Card cables from the Mini-Card, if applicable.
5. Make note of the cable routing and carefully dislodge the Mini-Card antenna cables from their routing guides.
ATI Mobility Radeon:
Mobile Intel® GMA:
Begin.
Removing the Center Control
Removing the Base Cover).
Before Working Inside Your
Cover).
Computer) before working inside the