Back to Contents Page
Camera (Optional)
Dell™ Inspiron™ 1545 Service Manual
Removing the Camera
Replacing the Camera
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE:
To help prevent damage to the system board, remove the main battery (see
computer.
NOTICE:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not
covered by your warranty.
Removing the Camera
1. Follow the instructions in
Before You
2. Remove the display assembly (see
3. Remove the display bezel (see
4. Remove the display panel (see
5. Remove the four screws securing the brackets to the camera board.
6. Remove the camera board brackets.
7. Disconnect the camera cable from the connector on the camera board.
8. Remove the camera board.
1
camera
3
camera board brackets (2)
Replacing the Camera
1. Align the camera board over the screw holes.
2. Replace the camera board brackets.
3. Replace the four screws that secure the camera board brackets to the display frame.
4. Connect the camera cable to the connector on the camera board.
5. Replace the display panel (see
Begin.
Removing the Display
Assembly).
Removing the Display
Bezel).
Removing the Display
Panel).
2
screws (4)
4
camera cable connector
Replacing the Display
Panel).
Before Working Inside Your
Computer) before working inside the