Back to Contents Page
USB Extend Cable
Dell™ Inspiron™ 1545 Service Manual
Removing the USB Extend Cable
Replacing the USB Extend Cable
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE:
To help prevent damage to the system board, remove the main battery (see
computer.
NOTICE:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not
covered by your warranty.
Removing the USB Extend Cable
1. Follow the instructions in
Before Working Inside Your
2. Remove the palm rest (see
3. Remove the two screws that secure the USB connector.
4. Remove the USB extend cable from the routing guide.
5. Disconnect the USB extend cable from the system board connector.
6. Lift the cable out of the computer base.
1
cable connector
3
screws (2)
Replacing the USB Extend Cable
1. Place USB connector along with the USB extend cable in the routing guide on the computer base.
2. Replace the two screws that secure the USB connector.
3. Connect the cable to the system board connector.
NOTICE:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in
damage to the computer.
4. Replace the palm rest (see
Back to Contents Page
Computer.
Removing the Palm
Rest).
2
cable routing
4
USB connector
Replacing the Palm
Rest).
Before Working Inside Your
Computer) before working inside the