Display Bezel; Replacing The Display Assembly; Removing The Display Bezel - Dell Inspiron 1545 Service manual Service Manual

1 Mini-Card antenna cable routing
slot
3 display cable pull-tab

Replacing the Display Assembly

1. Place the display assembly in position and replace the four screws (two on either side) that secure the display assembly.
2. Route the optional camera cable and display cable through the routing guides and connect the cables to the respective system board connectors.
3. Route the Mini-Card antenna cables into their routing guides on the palm rest and through the system board.
4. Replace the keyboard (see
5. Replace the center control cover (see
6. Replace the two screws at the computer base.
7. Turn the computer and route the Mini-Card antenna cables through their routing guides.
8. Connect the appropriate antenna cables to the Mini-Card. The following table provides the antenna cable color scheme for the Mini-Card supported by
your computer:
Connectors on the Mini-Card Antenna Cable Color Scheme
WLAN (2 antenna cables)
Main WLAN (white triangle) white
Auxiliary WLAN (black triangle) black
9. Replace the base cover (see
NOTICE: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in
damage to the computer.
10. Slide the battery into the battery bay until it clicks into place.
Display Bezel

Removing the Display Bezel

NOTICE: The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.
1. Remove the display assembly (see
2 camera cable connector (optional)
4 screws (4)
Replacing the Keyboard).
Replacing the Center Control
Replacing the Base Cover).
Removing the Display Assembly).
Cover).