Back to Contents Page
Keyboard
Dell™ Inspiron™ 1545 Service Manual
Removing the Keyboard
Replacing the Keyboard
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE:
To help prevent damage to the system board, remove the main battery (see
computer.
NOTICE:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not
covered by your warranty.
Removing the Keyboard
1. Follow the instructions in
Before You
2. Remove the center control cover (see
3. Remove the two screws at the top of the keyboard.
NOTICE:
The keycaps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Be careful when removing and handling the
keyboard.
NOTICE:
Be extremely careful when removing and handling the keyboard. Failure to do so could result in scratching the display panel.
4. Carefully slide the keyboard out of the computer and turn it over to access the keyboard connector. Do not pull hard on the keyboard.
1
keyboard
3
keyboard tabs (6)
5
keyboard cable
5. Lift the connector latch that secures the keyboard cable to the connector on the system board and remove the cable.
6. Lift the keyboard away from the computer.
Replacing the Keyboard
1. Slide the keyboard cable into the connector on the system board and press down on the connector latch that secures the keyboard cable to the system
board connector.
2. Align the tabs along the bottom of the keyboard with the slots of the palm rest and slide the keyboard under the palm rest.
NOTICE:
The keycaps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Be careful when removing and handling the
keyboard.
Begin.
Removing the Center Control
Cover).
2
screws (2)
4
connector latch
Before Working Inside Your
Computer) before working inside the