Related Manuals for Emerson HD7998
Summary of Contents for Emerson HD7998
- Page 1 Personal CD Player with Lightweight Stereo Headphones OWNER’ S MANUAL HD7998 Visit our web site at www.emersonradio.com HD7998_B081105.p65 11/8/2005, 15:05...
- Page 2 Thank you... For purchasing this Emerson Personal CD Player. The CD player has a 20 track programmable memory so you can listen to the songs on your favorite CD's in any order you choose. Or you can use the Shuffle playback feature and let the player select the playback order for you.
-
Page 3: Important Notes
IMPORTANT NOTES WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. Avoid installing the unit in locations described below: • Places exposed to direct sunlight or close to heat radiating appliances such as electric heaters. CLASS 1 LASER PRODUCT CLASS 1 LASER PRODUCT APPAREIL Á... -
Page 4: Preparation For Use
PREPARATION FOR USE Remove The Transit Card This personal CD player is shipped with a dummy CD ‘ transit card ‘ inside the CD compartment. The purpose of this card is to prevent the laser from moving during shipment of the product. This card must be removed before using the CD player. Slide the Open “... - Page 5 Connecting The Optional AC/DC Adapter (Not Included) 1.) Connect the small female plug of the optional AC adapter to the “DC 4.5V” jack on the right side of the CD player. 2.) Connect the adapter housing to your 120V 60Hz AC outlet. 20 TRACK PROGRAMMABLE CD PLAYER NOTES: •...
-
Page 6: Installing The Batteries
Installing The Batteries NOTE: The battery compartment is located inside the CD compartment. 1.) Slide the Open “ ” switch to the right to open the CD door. If you have not already done so, remove the dummy CD ‘ transit card’ and discard it. 2.) Press on the locking tab on the battery door in the direction of the “arrow”... - Page 7 BATTERY PRECAUTIONS • Replacement of batteries must be done by an adult. • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. • The supply terminals are not to be short-circuited. •...
-
Page 8: Location Of Controls And Indicators
LOCATION OF CONTROLS AND INDICATORS 20 TRACK PROGRAMMABLE CD PLAYER HD7998_B081105.p65 11/8/2005, 15:05... - Page 9 1.) CD Door. 2.) Battery Compartment (Inside CD compartment). 3.) DC 4.5V Input Jack – Connect an AC adapter (not included) to this jack to use 120V 60Hz AC house current. 4.) HOLD (On/Off) Switch – Slide to the right to lock the function of the control buttons.
-
Page 10: Lcd Display Indicators
LCD DISPLAY INDICATORS 1.) PGM (Program) Indicator – Appears when programming tracks or playing programmed tracks. 2.) ROCK, SRR, POP Indicators – Appears when repeatedly pressing the EQ button to select the corresponding EQ setting. 3.) VOL Indicator – Appears when pressing the VOLUME + or – buttons to adjust the volume level. -
Page 11: General Controls
OPERATING INSTRUCTIONS General Controls HOLD Switch The HOLD switch on the right side of the cabinet must be in the ‘ Off’ (left) position to start the CD player. If you plan to carry the CD player in a handbag, briefcase, school bag, back pack, etc, slide the HOLD switch to the ‘... -
Page 12: Normal Cd Playback
Normal CD Playback • Make sure you have installed the batteries. • Make sure the HOLD • Press the “VOLUME –” button to a low volume setting before you put on the headphones. 1.) Slide the CD door Open “ to unlock and open the CD door. -
Page 13: Pause Control
6.) Playback will continue until the end of the disc, then the player will stop automatically and the display will again show the total tracks and playing time on the disc. After approximately 30 seconds the power switches ‘ Off’ automatically to conserve the batteries and the display goes blank. - Page 14 MODE Button Pressing the MODE button during CD playback cycles the player through the following four special playback modes: 1(Repeat 1) (Shuffle) Playback. Repeat Playback The player can be programmed to continuously repeat a single track or the entire disc automatically. One Track Repeat During playback press the then press the MODE button once.
- Page 15 INTRO (Intro Scan) Playback The Intro Scan feature plays only the first 10 seconds of each track on the disc. This feature is useful when you are trying to find a particular song but you cannot remember the title. 1.) Load your disc in the player as usual and press the begin playback.
-
Page 16: Programmed Playback
Programmed Playback You can program up to 20 tracks on a disc to play in any desired order. Note: You can program a disc either during playback or in Stop mode. 1.) Press the PROG button once. The PGM indicator and the Track number “00”... -
Page 17: Care And Maintenance
When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the center out. SERVICE FOR ADDITIONAL SET-UP OR OPERATING ASSISTANCE PLEASE CALL: 1-800-898-9020 FOR CUSTOMER SERVICE, PLEASE WRITE TO: Emerson Radio Corp., Consumer Affairs Dept., 5101 Statesman Drive, Irving, TX 75063. HD7998_B081105.p65 11/8/2005, 15:05... - Page 18 For repair or replacement, pack your unit in a padded box, enclose your check or money order payable to Emerson Radio Corp. in the amount of $9.00 (not required by California residents) to cover shipping and handling costs, and enclose a copy of your proof of purchase.
- Page 19 EMERSON Part No. 16-2987B Printed in China 508-01 HD7998_B081105.p65 11/8/2005, 15:05...