Related Manuals for Emerson HD9116
Summary of Contents for Emerson HD9116
- Page 1 Personal CD-R/RW Player with 60 Second Anti-Shock and Wired Remote Control, Stereo Headphones, Car Kit OWNER’ S MANUAL HD9116BL Visit our web site at www.emersonradio.com HD9116_041006.p65 10/4/2006, 9:10...
- Page 2 Thank you... For purchasing this Emerson Personal CD Player. The CD player has a 20 track programmable memory so you can listen to the songs on your favorite CDs in any order you choose. Or you can use the Random playback feature and let the player select the playback order for you.
-
Page 3: Important Notes
IMPORTANT NOTES WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. Avoid installing the unit in locations described below: • Places exposed to direct sunlight or close to heat radiating appliances such as electric heaters. CLASS 1 LASER PRODUCT CLASS 1 LASER PRODUCT APPAREIL Á... -
Page 4: Preparation For Use
PREPARATION FOR USE Remove The Transit Card This personal CD player is shipped with a dummy CD ‘ transit card’ inside the CD compartment. The purpose of this card is to prevent the laser from moving during shipment of the product. This card must be removed before using the CD player. Slide the OPEN switch to the right to unlock the CD door. -
Page 5: Installing The Batteries
Installing The Batteries NOTE: The battery compartment is located on the bottom cabinet. 1.) Press the battery door locking tab in the direction of the ‘ Arrow’ to open the battery door. Lift the door upward as shown. 2.) Insert two alkaline “AA” batteries in the battery compartment. - Page 6 Connecting The Optional AC Adapter (Not Included) 1.) Connect the small female plug of the optional AC adapter to the “DC IN 4.5 V” jack on the right side of the CD player. 2.) Connect the adapter housing to your 120V 60Hz AC outlet. Notes: •...
- Page 7 Connecting The Stereo Headphones And Remote Control • Connect the plug of the supplied stereo headphones directly to the green-colored PHONES jack on the left side of the cabinet. • Or you may connect the headphones to the supplied Remote Control, then to PHONES jack.
-
Page 8: Location Of Controls And Indicators
LOCATION OF CONTROLS AND INDICATORS HD9116_041006.p65 10/4/2006, 9:10... - Page 9 1.) CD Door. PHONES Jack – Connect stereo headphones, included, to this jack. (Skip Reverse) Button. 4.) LCD Display – Shows Track number, Playing time, Anti-Shock status, Program, Repeat, Random, and Intro modes. 5.) PROG. (Program) Button. 6.) MODE Button – Selects the playback mode: Repeat 1/All, Shuffle, or Intro. (Skip Forward) Button.
-
Page 10: Lcd Display Indicators
LCD DISPLAY INDICATORS LCD Display 1.) Elapsed Time (Minutes) Display. 2.) Volume level (00-32) and Track Number Display. 3.) VOL (Volume) Indicator – Appears when adjusting Volume level. 4.) PROG (Program) Indicator – Appears when programming tracks or playing programmed tracks. 5.) RAND (Random) Indicator –... -
Page 11: Special Functions
OPERATING INSTRUCTIONS Special Functions HOLD Switch (On Wired Remote Control Only) The HOLD switch on the side cabinet of the wired remote control must be in the ‘ Off’ (left) position to start the CD player with the wired remote control. While the HOLD switch is ‘... - Page 12 Electronic Anti-Shock Protection This CD player includes an Electronic Anti-Shock Protection circuit that continuously stores 60 seconds of CD music in an electronic memory. If the player is bumped or shaken you will not hear any skipping because the player is reading from the memory, not directly from the disc.
-
Page 13: Normal Cd Playback
Normal CD Playback • Make sure you have installed the batteries. • Make sure the HOLD switch on the wired remote control is set to the ‘ Off’ (left) position. • Make sure to set the VOL control to a low setting before you put on the headphones. -
Page 14: Pause Control
5.) Adjust the VOL+ / –, and DBBS controls as desired. 6.) Playback will continue until the end of the disc, then the player will stop automatically and the display will again show the total tracks and playing time on the disc. After approximately 30 seconds the power switches ‘ Off’ automatically to conserve the batteries and the display goes blank. -
Page 15: Mode Button
MODE Button Pressing the MODE button during playback cycles the player through the following four special playback modes: REPEAT 1 REPEAT ALL Repeat Playback The player can be programmed to continuously repeat a single track or the entire disc automatically. One Track Repeat During playback press the then press the MODE button once. - Page 16 INTRO (Intro Scan) Playback The Intro Scan feature plays only the first 10 seconds of each track on the disc. This feature is useful when you are trying to find a particular song but you cannot remember the title. 1.) Load your disc in the player as usual and press the begin playback.
-
Page 17: Programmed Playback
Programmed Playback You can program up to 20 tracks on a disc to play in any desired order. NOTE: You can program a disc either during playback or in Stop mode. 1.) Press the PROG button once. The PROG indicator and and the track number ‘... - Page 18 Using The Car Cassette Adapter Compact discs played in this unit can be heard through a car cassette deck by using the CD cassette adapter. When listening to a CD in the car, use the supplied CD cassette adapter to play a CD through a car stereo cassette deck. Operating instructions 1) Insert the cassette adapter plug into the NOTE: Make sure that the cassette adapter plug is inserted into the...
- Page 19 Using The Car DC-DC Converter You can save money on batteries by using the supplied Car DC-DC Converter. 1) Insert the small end of the Car DC-DC Converter into the DC IN 4.5V Input Jack on the CD player. 2) Insert the large end of the Car DC-DC Converter into the car cigarette lighter socket.
-
Page 20: Care And Maintenance
CARE AND MAINTENANCE Cleaning the Lens A dirty lens will cause sound skipping and, if the lens is very dirty, the CD may not work. Open the disc cover and clean the lens as follows: Dust or Dry Particles Using a camera lens brush/blower, blow on the lens several times, then wipe it lightly with the brush to remove dust. -
Page 21: Cleaning The Cabinet
FOR CUSTOMER SERVICE,PLEASE WRITE TO: HD9116_041006.p65 TO FIND THE LOCATION AND PHONE NUMBER OF YOUR NEAREST SERVICE CENTER PERMITTED TO PERFORM WARRANTY... 1-800-695-0098 PLEASE CALL: 1-800-898-9020 Emerson Radio Corp., Consumer Affairs Dept., 5101 Statesman Drive, Irving, TX 75063. 10/4/2006, 9:10... - Page 22 For repair or replacement, pack your unit in a padded box, enclose your check or money order payable to Emerson Radio Corp. in the amount of $9.00 (not required by California residents) to cover shipping and handling costs, and enclose a copy of your proof of purchase.
- Page 23 HD9116-040306-01 Printed in China HD9116_041006.p65 10/4/2006, 9:10...