Normal Playback - Emerson HD9971 Owner's Manual

NORMAL PLAYBACK

1.) Connect the headphones to the Headphone jack.
2.) Set the VOLUME control to minimum.
3.) Press the CD door OPEN
button to open the CD door. Place
your CD on the center spindle,
label side up and gently press
down until it is firmly held in place.
4.) Close the CD door and push down
on the "CLOSE" position, to make
sure that the door locks properly.
5.) Slide the HOLD switch to the "OFF" position.
6.) Press the PLAY/PAUSE
playing time will show on the display window. The player will then start playing
track 1 automatically. Track number and elapsed playing time are displayed.
7.) Adjust the VOLUME and DBBS (Bass Boost)controls as desired.
8.) When all tracks have been played the player stops and the display shows the
total tracks and playing time on the disc. After approximately 1 minute the
power shuts off and the display goes blank.
To stop playback before the disc ends press the STOP
Press the STOP
9.) Press the OPEN
CD Door and return your disc to its protective storage case.
HD9971_ib_drafts.p65
OPERATING INSTRUCTIONS
button and the total number of tracks and total
button again to shut the power off immediately. .
button to open the door and remove your disc. Close the
7
7
V O L U M E
button at any time.
19/4/2002, 15:52