Table of Contents
Advertisement
Quick Links
Universal Tilting TV Mount - 23" to 42"
Tilting Flat-Panel TV Wall Mount
Material: 2.0mm Cold Rolled Steel Plate
TV Size: 23" - 42"
Tilt: 0 / +15 degrees
Maximum load capacity: 99lbs / 45kgs
Wall distance: 3.1" / 80mm
Bubble level included
Universal Mounting Pattern
IMPORTANT: If you don't understand the installation instructions, please
consult an installation specialist
04-0676A
Installation Instructions
1
Advertisement
Table of Contents
Related Manuals for SIIG Universal Tilting TV Mount - 23" to 42
Summary of Contents for SIIG Universal Tilting TV Mount - 23" to 42
-
Page 1: Installation Instructions
Universal Tilting TV Mount - 23" to 42" Installation Instructions Tilting Flat-Panel TV Wall Mount Material: 2.0mm Cold Rolled Steel Plate TV Size: 23" - 42" Tilt: 0 / +15 degrees Maximum load capacity: 99lbs / 45kgs Wall distance: 3.1" / 80mm Bubble level included Universal Mounting Pattern IMPORTANT: If you don't understand the installation instructions, please... - Page 2 INSTALLATION AND OPERATING INSTRUCTIONS Caution Prior to the installation of this product, the installation instructions should be read and completely understood. The installation instructions must be read to prevent personal injury and property damage. Keep these installation instructions in an easily accessible location for future reference. CAUTION: The maximum load capacity is 99lbs.
- Page 3 Note: 1. Please ensure that the bubble level (G2) is properly attached to the wall plate prior to mounting. 2. Please check the two rails before installing, if without the knob, please install the knob. Step 1: Wall plate installation A) Wood Stud Installation NOTE: For secure wood stud mounting, the wall plate must be mounted to two studs at least 16"...
- Page 4 B) Concrete/Brick Installation NOTE: The concrete anchors must be used for concrete installation. Attach the bubble level (G2) to the wall plate, with the help of an assistant place the wall plate into position against the wall, using the bubble level to keep it level. Mark four holes to be used for securing the mount and place the wall plate aside.
- Page 5 Step 3 Final Installation & Adjustment Hook the TV rails over the top of wall plate. The TV rail can be tilted down up to 15 degrees. To make this adjustment, first loosen the knob and pull or push the rail until it is in the desired position. Once the desired level of tilt is achieved, re-tighten the mount by turning the tension knobs.
- Page 6 Blank Page...
- Page 7 Step 1: Submit your RMA request. Go to www.siig.com, click Support, then click RMA to submit a request to SIIG RMA or fax a request to 510-657-5962. If the product is determined to be defective, an RMA number will be issued.
- Page 8 Universal Tilting TV Mount - 23" to 42" Universal Tilting TV Mount - 23" to 42" is a trademark of SIIG, Inc. SIIG and the SIIG logo are registered trademarks of SIIG, Inc. Other names used in this publication are for identification only and may be trademarks of their respective owners.
Need help?
Do you have a question about the Universal Tilting TV Mount - 23" to 42 and is the answer not in the manual?
Questions and answers