Advertisement
Quick Links
Full-motion/articulating universal LCD/Plasma TV wall-mount
TV size: 23" - 42"
Tilt angle: 0-12 degrees
Max load capacity:100 lbs
Wall distance: 3.75" / 95mm
Built-in bubble level
Universal Mounting Pattern
IMPORTANT: If you have difficulty following or understanding these installation instructions,
please consult a qualified service technician.
04-0621A
Full Motion TV Mount - 23" to 42"
Installation and Operating Instructions
1
Advertisement
Related Manuals for SIIG Full Motion TV Mount - 23" to 42
Summary of Contents for SIIG Full Motion TV Mount - 23" to 42
- Page 1 Full Motion TV Mount - 23" to 42" Installation and Operating Instructions Full-motion/articulating universal LCD/Plasma TV wall-mount TV size: 23" - 42" Tilt angle: 0-12 degrees Max load capacity:100 lbs Wall distance: 3.75" / 95mm Built-in bubble level Universal Mounting Pattern IMPORTANT: If you have difficulty following or understanding these installation instructions, please consult a qualified service technician.
-
Page 2: Hardware Kit
INSTALLATION AND OPERATING INSTRUCTIONS Caution Prior to the installation of this product, the installation and operating instructions should be read and completely understood. The installation and operating instructions must be read to prevent personal injury and property damage. Keep these installation and operating instructions in an easily accessible location for future reference. CAUTION: The maximum load capacity is 100 lbs. -
Page 3: Tools Required
Tools Required: Phillips head screw driver Stud finder for drywall installation 5/16" Socket and Wrench Electric drill, 3/16 drill bit for wood stud installation, and 1/2" (12mm) masonry bit for concrete/brick installation Note: Please ensure that the bubble level is properly mounted on the wall plate prior to mounting the wall plate. Step1: Wall Plate Installation a) Wood Stud Installation Note: When mounting to wood studs, the two wood studs must be a minimum of 16"... - Page 4 b) Concrete / Brick Installation Note: The concrete anchors must be used for concrete and brick installation. Begin by placing the wall plate into position against the wall, using the bubble level to keep it level. Locate the holes directly into the block or concrete, never into the mortar between the blocks (Figure 2).
-
Page 5: Maintenance
Step 3 Final Installation & Adjustment Hang the display plate onto the top of the wall plate and slip onto the wall plate as shown (Figure 5). Tilt the display to the desired angle (Figure 6). Tighten the middle screw to secure the tilt angle (Figure 7). Tighten the bottom screw to lock the bracket (Figure 8). - Page 6 Blank Page...
-
Page 7: Technical Support And Warranty
• You are responsible for the cost of shipping. Ship the product to the following address: SIIG, Inc. 6078 Stewart Avenue Fremont, CA 94538-3152, USA RMA #: ________________ • SIIG will ship the repaired or replaced product via Ground in the U.S. and International Economy outside of the U.S. at no cost to the customer. - Page 8 Full Motion TV Mount - 23" to 42" Full Motion TV Mount - 23" to 42" is a trademark of SIIG, Inc. SIIG and the SIIG logo are registered trademarks of SIIG, Inc. All other names used in this publication are for identification only and may be trademarks of their respective owners.