Table of Contents
Advertisement
b) Concrete/Brick Installation
NOTE: The concrete anchors must be used for concrete installation.
With the help of an assistant, and using a bubble level to ensure the wall plate is level, position the wall plate
1
against the wall in the desired mounting location.
Mark four holes to be used for securing the mount and place the wall plate aside.
2
3
Next, drill holes using a 3/8" masonry drill bit to a depth of approximately 3".
Insert a concrete anchor into to each hole.
4
5
If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush with the wall.
6
Once all of the anchors are in place, move the wall plate back into position.
Insert bolt (I) into each concrete anchor in the wall.
7
Do not tighten until all bolts are in place.
8
Tighten the bolt with the 1/2" socket or 1/2" open-end wrench by turning clockwise until tight.
9
CAUTION: Do not over-tighten bolts - doing so may cause unnecessary damage to the wall.
CAUTION: Do not release the wall plate until it is properly mounted and secured to the wall.
4
Advertisement
Table of Contents
