Unpacking Instructions; Tools Needed For Assembly - Emerson CF943 Owner's Manual

BP7335 Palazzo 1/9/07
This Manual is Designed to Make it as Easy as Possible for You to
Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver
One wire stripper
One stepladder
Two 60-watt candelabra base bulbs
(not supplied)
Materials
Wiring, outlet box and box connectors
must be of type required by the local code.
The minimum wire would be a 3-conductor
(2-wire with ground) of the following sizes:
For your convenience, check-off boxes are provided next to each step. As each
step is completed, place a check mark in the box. This will insure that all steps
have been completed and will be helpful in finding your place should you be
interrupted.
WARNING
!
Do not install or use fan if any part is
damaged or missing. Call Toll-Free:
1-800-654-3545
WARNING
!
This product is designed to use only
those parts supplied with this product
and/or any accessories
specifically for use with this product by
Emerson Electric Co. Substitution of
parts or accessories not designated for
use with this product by Emerson Electric
Co. could result in personal injury or
property damage.
1. Open carton containing fan. Remove
top half of styrofoam unit. Remove
parts and check to see that you have
received the following parts:
NOTE: If you are uncertain of part
description, refer to exploded view
illustration.
9:05 AM Page 3
Installed Wire Length
Up to 50 ft.
50-100 ft.
Before assembling your ceiling fan, refer
to the section on proper method of wiring
your fan (Page 11). If you feel you do not
have
experience, have your fan installed by a
licensed electrician.

Unpacking Instructions

a. Fan motor assembly
b. One coupling cover
c. One ceiling cover
d. Five fan blades
e. Five blade flanges
f. One light kit assembly
g. One hanger bracket
h. One hanger ball/6" downrod assembly
i. One glass shade
j. One fan/light wall control
designated
(transmitter and receiver)
k. One loose parts bag containing:
1. One clevis pin
2. One hairpin clip
3. Five wire connectors
4. Two #8-32 x 1-1/4" threaded studs
(ceiling cover)
5. Two #8 external tooth lockwashers
(ceiling cover)
6. Two #8-32 knurled knobs
(ceiling cover)
7. Sixteen #10-32 x 5/16" pan head
blade screws
8. Sixteen #10 flat blade washers
9. Eleven #8-32 x 1-1/4" oval head
screws
10. Four #8-32 x 1/4" pan head screws
(light kit assembly)
3
Wire Size A.W.G.
14
12
WARNING
!
enough wiring knowledge or