Emerson CF943 Owner's Manual page 8

BP7335 Palazzo 1/9/07
FAN BLADE
Figure 6
NOTE: Take care not to scratch fan
housing when installing blades.
2. Position the bottom half of the
styrofoam packaging on the floor
(Figure 7). Turn the fan motor assembly
upside down onto the styrofoam in
preparation for mounting the fan blade
assemblies.
FAN MOTOR ASSEMBLY
(Flange Slots Facing Up)
Figure 7
3. Carefully slide one blade assembly into
the motor housing assembly flange
slot. Attach the blade assembly using
two #10-32 x 5/16" oval head flange
screws (Figure 8). Make sure the
screws are securely tightened. Repeat
this procedure for the other four blade
assemblies.
MOTOR HOUSING
ASSEMBLY FLANGE
SLOT
Figure 8
9:05 AM Page 8
4. Securely connect the black wire
connector of the light fitter assembly to
#10-32 x 5/16" PAN
HEAD BLADE SCREW
the black motor wire connector.
(3 per blade)
Securely connect the white wire of the
#10 FLAT BLADE
light fitter assembly to the white motor
WASHER
wire (Figure 9).
(3 per blade)
LIGHT FITTER
BLADE
BLACK WIRE
FLANGE
LIGHT FITTER
WHITE WIRE
Figure 9
5. Position the light fitter assembly so that
the three holes align with the one hole
and two keyhole slots in the light kit
adapter plate (Figure 10).
6. Attach the light fitter assembly to the
light kit adapter plate by securely
installing the three #8-32 x 1/4" pan
head screws (supplied in the loose
parts bag) (Figure 10).
BOTTOM
To avoid possible fire or shock, make
HALF OF
STYROFOAM sure that the wires are not pinched
between the light fitter assembly and the
light kit adapter plate. Pinched wires will
also cause the light fitter assembly to
mount crooked on the light kit adapter
plate.
LIGHT FITTER
ASSEMBLY
#10-32 x 5/16" OVAL
HEAD FLANGE SCREW
(2 per flange)
BLADE
ASSEMBLY
Figure 10
8 8
LIGHT FITTER
ASSEMBLY
MOTOR HOUSING
BLACK WIRE
MOTOR HOUSING
WHITE WIRE
LIGHT KIT
ADAPTER PLATE
WARNING
!
#8-32 x 1/4" PAN
HEAD SCREW (3)