Emerson CF943 Owner's Manual page 12

BP7335 Palazzo 1/9/07
f. Cap the receiver yellow wire using a
wire connector (supplied).
g. Connect the green ground wires
from the hanger bracket and the
hanger ball to the supply ground
wire (bare or green).
HANGER BRACKET
HANGER BRACKET
GROUND WIRE
(GREEN)
HANGER BALL
GROUND WIRE
(GREEN)
SUPPLY GROUND
WIRE (GREEN OR
BARE)
RECEIVER
WHITE SUPPLY
WIRE
CEILING COVER
Figure 20
SW105 RECEIVER
BLACK
SUPPLY
WIRE
WHITE
RECEIVER
WIRE
BLACK
RECEIVER WIRE
BLACK/WHITE
RECEIVER WIRE
WHITE FAN WIRE
BLACK FAN WIRE
Figure 21
9:05 AM Page 12
Check to see that all connections are
tight, including ground, and that no bare
wire is visible at the wire connectors,
except for the ground wire. Do not
operate fan until blades are in place.
Noise and fan damage could result.
OUTLET BOX
OPEN
PORTION OF
RECEIVER
HERE
WHITE FAN WIRE
WIRE CONNECTOR
4. After connections have been made,
TO
110V
separate the white and green wires
SUPPLY
from the black and blue wires.
SW113
FAN/LIGHT
5. Carefully turn the wires upward and
WALL
insert them up through the open side of
CONTROL
HI
U/L
MED D/L
LOW
REV
FAN OFF
the hanger bracket and into the outlet
OFF ON
WHITE
SUPPLY
box. Push the green and white wires
WIRE
into one side of the outlet box; push the
BLUE RECEIVER
WIRE black and blue wires into the other side
YELLOW
of the outlet box.
RECEIVER WIRE
6. Screw two 1-1/4" threaded studs
CAP THE
YELLOW
(supplied in the loose parts bag) into the
RECEIVER WIRE
tapped holes in the hanger bracket
USING A WIRE
CONNECTOR (Figure 22).
BLUE FAN WIRE
DOWNROD
12
WARNING
!
BLACK SUPPLY WIRE
BLACK FAN WIRE
BLACK/WHITE RECEIVER WIRE
BLUE FAN WIRE
BLUE RECEIVER
WIRE
CAP THE YELLOW RECEIVER WIRE
USING A WIRE CONNECTOR
BLACK RECEIVER WIRE
WHITE RECEIVER WIRE