Getting Started; Accessory List; Turning Power On And Off; Source Selection - Alpine CDE-147BT Manual

Getting Started

Rotary encoder

/ENTER
/ 
AUDIO/SETUP
SOURCE
e

Accessory List

• Head Unit ..................................................................................1
• Power Cable ..............................................................................1
• USB Cable..................................................................................1
• Microphone ..............................................................................1
• Bracket Key ...............................................................................2
• Mounting Sleeve ......................................................................1
• Carrying Case............................................................................1
• Screw (M5 × 8) ..........................................................................4
• Owner's Manual..................................................................1 set

Turning Power On and Off

Press t to turn on the unit.
Note
• The unit can be turned on by pressing any other button except  and
e (Release).
• VSOURCE key blinks each time the unit is powered on.
Press and hold t for at least 2 seconds to turn off the
unit.
Note
• The first time power is turned on, the volume will start from level 12.

Source Selection

Press VSOURCE to change the source.
*1 *2
 SIRIUSXM
TUNER /HD RADIO
*4 *5
 BT AUDIO
USB AUDIO /iPod
*8
 TUNER/HD RADIO
AUXILIARY
CDE-147BT only
CDE-HD148BT only
Displayed only when a SiriusXM Tuner is connected.
(CDE-HD148BT only)
Displayed only when no iPod/iPhone is connected.
Displayed only when the iPod/iPhone is connected.
Displayed only when BT IN is set to ON, refer to "Setting the
BLUETOOTH Connection (BT IN)" on page 30.
Not displayed when ALPINE APP is set to OFF, refer to "Setting
the communication mode with a Smartphone (ALPINE APP)"
on page 29.
*3
 DISC 
*6 *7
 PANDORA 
Displayed only when AUX SETUP is set to ON. Refer to "Setting
the AUX SETUP mode" on page 27.

Detaching and Attaching the Front Panel

Detaching

1
Turn off the unit power.
2
Press e (Release) at the lower left side until the front
panel pops out.
3
Grasp the left side of the front panel and pull it out.
Notes
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it may
result in malfunction.

Attaching

1
Insert the right side of the front panel into the main unit.
Align the groove on the front panel with the projections
on the main unit.
2
Push the left side of the front panel until it locks firmly into
the main unit.
Notes
• Before attaching the front panel, make sure that there is no dirt or dust
on the connector terminals and no foreign object between the front
panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.
9
-EN