Download Print this page

Lightolier WIRING OF AGILI-T FIXTURES Instructions For Maintenance Reference

Wiring of fixures

Advertisement

Quick Links

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector
before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
ELECTRICAL
PANEL
(BLACK, RED
WHITE, GREEN)
NETWORK WIRING FOLLOW:
(PURPLE, GREY)
OUTLET
1. BLACK (LINE 1)
2. RED (LINE 2)
3. WHITE (NEUTRAL)
4. GREEN (GROUND)
5. PURPLE (DALI CONTROL)
6. GREY (DALI CONTROL)
INSTRUCTIONS FOR WIRING OF AGILI-T FIXTURES
BIAX CABLE
JUNCTION
BOX
BUS
COMPUTER
TRANSFORMER
120V TO 12V AC
BIAX CABLE
NOTE: If supply wires are located within three inches (76.2mm)
of ballast, use wire rated for at least 90 °C
POWER FEED
END CAP
INSTRUCTION SHEET NO.
SH20300
JUNCTION BOX
TEE-BAR
CANOPY
FIXTURE
RECOGNIZED
JUNCTION BOX
BY OTHERS
RECOGNIZED
2
4
6
3
5
1
STRAIN
RELIEF
BY OTHERS
525 Education Road, Cornwall K6H 6C7
Tel:(613)938-6221 Fax:(613)938-0961
Page 1 0f
1
Page 1
Rev.01

Advertisement

loading
Need help?

Need help?

Do you have a question about the WIRING OF AGILI-T FIXTURES and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

This manual is also suitable for:

Agili-t series