Table of Contents
Advertisement
Preparation
Install Display on solid horizontal surface such as a table or desk.
For ventilation, leave a space of at least 10 cm free all around the set. To prevent any fault and
unsafe situations, please do not place any objects on top of the set.
Installation of device on the wall
Step1:
Invert the flat monitor screen and placed it on a flat surface. Remove the foot top cover. Re-
move the back support from the screen. Replace the support with the mounting bracket align
the holes from the bracket with the mounting holes found on the back of the monitor chassis.
Secure the bracket with the same four (4) 4 (mm) head screws.
Step 2:
Choose the wall where the monitor
would be located. Level and mark
with a pencil the four (4) mounting
points found on the wall bracket.
Drill pilot holes for the plastic an-
chors then secure the wall bracket
with the four (4) L=32 mm x D=5
mm screws (supplied).
Step 3:
Raise the monitor with the mounting
bracket attached and slip the top
opening to the safety flange on the
secured wall bracket. Let the moni-
tor fall in place safely and secure the
foot assembly
two (2) D=4 mm x L=10 mm
safety screws (supplied) with a long
screwdriver for additional security.
back support
Note:
Do not over tighten!
6
Advertisement
Table of Contents
