Table of Contents
Advertisement
Picture Mode
Picture mode OSD is displayed when "
key is pressed. Picture mode can be changed to
Auto, 4:3, 16:9, Cinema, Subtitle, Zoom or
Panorama by pressing "
Sleep Timer Indicator
It is displayed on the upper right of the screen when a
new programme is entered by digit key or by press-
ing "P<P", "-P/CH", "P/CH+", "TV", "AV" or
"
" key. If sleep timer is activated it is displayed
with the TV status and erased with it after 3 seconds.
Once the time set with the sleep timer has elapsed,
the set will go to standby.
Mute Indicator
It is placed in the upper middle of the screen when
enabled, and it stays there until it is disabled.
To cancel mute, there are two alternatives; the first one
is pressing " " key, the volume is set to the preced-
ing value. The second one is increasing the volume
level, whereby it starts at the minimum level to in-
crease. By decreasing the volume level in mute state,
mute will not be ignored, only the volume level will de-
crease. If mute is cancelled after decreasing the vol-
ume level, the volume will be set the decreased level.
No-Signal Detection (TV)
If no valid signal detected, it takes 5 minutes for the
set to switch to Standby mode unless a signal is de-
tected or a command is received from the remote
control.
After a Remote Control command (if No-Signal Timer
is active) the timer stops and if no signal detected
again the timer is initialized to 5 minutes and starts 3
seconds later again to count down.
It is not valid in AV mode.
56
WIDE"
WIDE" key. .
0:15
4:31
No-Signal Detection (PC)
If no valid signal detected for 5 minutes system goes
to Stand-By mode. To switch on the system press
"
" key. .
As the last status feature, system starts from TV or
PC, whichever was the status before stand-by or
switch-off. Note that SCART inputs have the prece-
dence on both TV and PC.
Volume Bar
It is displayed in the lower middle of the screen. When
a volume command is received (pressing "
or "
-" by Remote Control or Control panel at
the top of the TV) and no menu is active, it stays on
the screen for 3 seconds, after the last volume com-
mand or until another command is received in be-
tween.
AV Modes
By pressing the "AV" key you can switch your TV to
AV modes (except being in Teletext). Pressing this key
will consecutively switch the TV in one of the optional
AV modes: AV-1, AV-2, AV-3, S-VIDEO, PC.
In order to quit the AV mode press the "TV", digit
keys or "-P/CH" or "P/CH+" .
Signal Out Of Range
When the PC input signal is not supported by LCD-
TFT TV, a message is displayed like "Signal out of
range" and screen is blanked.
+"
Advertisement
Table of Contents
