Table of Contents
Advertisement
2.
Short press PTT button again and the radio
signals the second digit "1".
3.
Short press PTT again and radio signals the
third digit "8".
Reading Auto-Scan Values
After finishing reading CTCSS/DPL codes, if
you short press PTT once again, the radio
takes you to Auto-Scan as per "Advanced
Configuration (RDM2020 Model)" on page 44
(Step 3). Auto-Scan only has two values:
Radio Signal Value
0
1
Note:
Auto-Scan is set to OFF by default.
Changing Values
Each time the radio signals and beeps, the
current value can be changed by short
pressing SB1 to increase or by short pressing
SB2 to decrease. The radio will then signal the
new setting it has been configured to.
To abort the value configured, turn the radio
OFF or change channel using the channel
knob.
If the radio "rolls-over" to the "Idle" Advanced
Configuration Mode, the radio emits a "chirp"
and radio LED starts blinking green again. All
Status
values that were changed are automatically
saved.
OFF
ON
47
English
Hide quick links:
Advertisement
Table of Contents
