Table of Contents
Advertisement
PREPARATION
Remote Control Battery Installation
The remote control operates on 2 "AA" batteries.
1. Open the battery compartment cover
Slide open the battery compartment cover on the backside
in the direction of the arrow, and remove the cover.
2. Install the batteries
Install 2 "AA" batteries (included)
making sure the polarities match
the indication inside the
compartment.
3. Close the battery
compartment cover
Make sure the projections
locate in the corresponding
holes and slide the
compartment cover until it
clicks shut.
CAUTION
Risk of corrosion or battery leakage possibly resulting in physical injury
and/or property damage including fi re.
Never mix used and new batteries in the device.
Replace all the batteries in the device at the same time.
Remove the batteries if the remote control is not going to be used for an extended period of time.
To avoid possible malfunction, read the following instructions and handle
the remote control correctly.
Do not drop or allow impact to affect the remote control.
Do not spill water or any liquid on the remote control.
Do not place the remote control on a wet surface.
Do not place the remote control under direct sunlight or near sources of excessive heat.
Caution When Moving the Main Unit
Whenever the unit is moved, two people are required to transport it safely.
Whenever the unit is moved,
it should be lifted forwards
by holding the top and base
on both sides of the unit for
stability.
13
Handling the Remote Control
Use the remote control within a distance of
about 5m from the front of the unit's remote-
control sensor and within an angle of about
30 degrees on both sides.
Within 30
degrees
About 3m
Within 30
degrees
About 3m
About 5m
Advertisement
Table of Contents
