Table of Contents
Advertisement
Figure 2.2
It may be necessary to cut ribs and struts inside the bezel. Cutting these ribs and
struts does not usually cause difficulties, although the stiffness of the bezel may
be reduced slightly. Try not to cut into the posts for the CRT attachment screws.
Bezel and tube combinations that require this cut are rare.
Generally, a total clearance between the edge of the touchscreen and any ribs or
struts of at least 0.25-inch (6 mm) in both axes is necessary. This prevents the
interference fit problem and allows for variation in touchscreen mounting
position.
CRT Integration
Safety Information
Before proceeding with the installation, prepare a padded work surface. A
plastic waste basket is recommended for supporting the CRT during part of the
installation. Wear safety glasses, gloves, a rubber apron, and heavy protective
clothing for any portion of this procedure that involves handling or working
near the CRT.
Note:
This document describes the basic tasks common to the majority of CRT monitor
integrations. These instructions assume an audience of trained integration personnel.
2-8
I n t e l l i T o u c h / S e c u r e T o u c h G u i d e
Bevel edge for nice appearance
Round corners for nice appearance and easy cleaning
On bezel and cabinet, choose paint finish and/or
surface texture so fingerprints do not show
Bezel edge
Advertisement
Table of Contents
Troubleshooting
