Wakeup On Lan Criteria; Installing The Lan Driver; Enabling Wakeup On Lan In Scu; Using A Remote Access Utility - EUROCOM LP200ST User Manual

W LAN C
AKEUP ON
To enable the system to be remotely accessible via LAN, make sure you have complied with
the following besides attending to the above-mentioned password protection issues:

• Installing the LAN driver

• Enabling Wakeup on LAN in SCU

• Installing a remote access utility (depending on your needs)
I LAN D
NSTALLING THE
If you haven't installed the LAN driver, refer to Chapter 5, Drivers & Utilities, (operating sys-
tem), LAN for installation instructions.
E W
NABLING AKEUP ON
This allows the system to be waken up from standby via
LAN.
Note:
( SCU > Power menu > Wakeup on LAN)
U R A
SING A EMOTE CCESS
Depending on your needs, you may or may not need to install a remote access utility. For ex-
ample, a remote system can wake up your system using the Windows built-in Ping command if
both systems are in a TCP/IP network. Refer to Windows Help for information on how to use
this command. If you need to use a remote access utility, consult the utility's user documenta-
tion for setup information.
RITERIA
RIVER
LAN SCU
IN
U
TILITY
Wakeup on LAN
Consideration
Do not keep Wakeup on LAN always
enabled if you do not want a remote
system to access your system while
it is on standby.

wakeup on LAN criteria

3
3 – 21