SP Controls PixiePlus Projector Controller for Epson Installation Manual page 5

III. PixiePlus Installation
The Projector Controller for Epson is preconfigured to use the Discrete Power, 4-
Button Source, and Volume Control button modules. To function with the PixiePlus
preconfiguration codes, these button modules must be used.
If you wish to reconfigure the PixiePlus with alternate controls, you may replace
those button modules as needed with buttons that match the control codes you
wish to use. Select the button insert modules that match the design of your remote
control. For example, if your remote control has a single toggling power button,
select the Toggling Power module.
Reprogramming the PixiePlus RS-232 commands requires use of the PixiePlus
programming tool (PXE-PGM-TOOL).
1. Assemble Insert Modules
Available Insert Modules
POWER
Toggling
SOURCE
Toggling
VOLUME
Control
Note: You must chose one (and only one) insert module of each type. That is, you
cannot use two source insert modules and no volume module.
POWER
ON OFF
Discrete
SOURCE
VIDEO
COMP
Discrete
(2-Button)
Blank
SOURCE
comp video
audio
Discrete
(4-Button)
4