If the room is too bright, the PixiePlus will not enter learning mode. The LED will
glow solid red, the buttons will beep continually when pressed, and they will not
arm for learning. Darken the room or shield the PixiePlus from the ambient light
while learning. Direct sunlight is always too bright.
3. Test Remote and Identify Sweet Spot: Position the remote control a few inch-
es from the IR learning eye (upper right of PixiePlus front).
When you press a key on the remote, the PixiePlus status LED should flicker. As
you move the remote closer or farther from the receiver window, or move off axis
the red flashes will dim and become intermittent. Find a position that consistently
yields clear, regular blinking. This is the "sweet spot."
If you do not see the Status LED flicker rapidly, your remote may need new
batteries.
Some remotes have several emitting LEDs, which may not be located in
the center of the remote.
4. Round Robin Codes and Macros
Each PixiePlus button may be programmed with either a single command or multi-
ple commands (as many as four). Multiple commands may be sent round robin or
as macros. Round robin buttons send one command per button press. Each time
the button is pressed, it sends the next code in the series. Macro buttons send all
programmed codes each time the button is pressed.
Example - Round Robin: The SOURCE toggle button may be programmed with
four round robin commands to switch between four inputs on the display device.
The single SOURCE button is programmed with all four input commands, and con-
figured to Round Robin mode. Each time the SOURCE button is pressed, it sends
one of the four commands, in the order learned.
Example - Macro: The COMP input button may be programmed with two com-
mands and configured to macro mode. The COMP button is programmed so that
each time it is pressed it sends the RGB1 input command, followed by the auto-
sync command.
RGB1
Video
Remote Control
RGB
Video
V. Reprogram PixiePlus cont'd
SOURCE
VIDEO
COMP
Source Module
10
Need help?
Do you have a question about the PixiePlus Projector Controller for Epson and is the answer not in the manual?