SP Controls PixiePlus Projector Controller for Epson Installation Manual page 12

5. To program a button with a single code: While the PixiePlus is in learning
mode, press the button to be programmed to arm it. It should beep once and slow-
ly blink.
If the button beeps loudly as soon as you press it, check if the Status LED
is solidly lit. If it is, there may be too much light in the room. Reduce the
ambient light level or shield the PixiePlus from the light source and try again.
Hold the remote control in the sweet spot you found in step 3. Press and hold the
button on the remote for about a second. The status LED should flicker, indicating
that the code is being received. The PixiePlus will beep three times quickly to indi-
cate successful learning.
You may press a different button for learning at any time, including buttons that
have already been programmed. If you press a button that is already armed for
learning a second time, it will be disarmed.
If the PixiePlus learns the code, the button will begin flashing rapidly in Verification
Mode. Go to step 7, Verify Learned Keys.
6. To program a button with multiple codes for macro or round robin com-
mands: Put the PixiePlus in learning mode. Quickly press the button you wish to
program one time for each code you want it to learn. The PixiePlus will beep once
for each code it expects to learn.
Example: If you wish to program a SOURCE button with three codes, set the
PixiePlus to learning mode and quickly press the SOURCE button three times. The
PixiePlus will beep three times to indicate it is ready to learn three codes.
V. Reprogram PixiePlus cont'd
11