Technical Specifications - SP Controls PixiePlus Projector Controller for Epson Installation Manual

Confirm that the IR emitter bud is positioned directly over the receiver on the IR
window of the device you are controlling. Some devices are sensitive to accurate
placement.
Fluorescent lights can interfere with IR signals. Check if the projector is close to a
fluorescent light source. If so, try turning off the lights. If this restores control, cover
the IR emitter bud and display device IR receiver window with an IR-opaque shield,
such as gaffer's tape. Some opaque tapes do not block IR.
Power and Source Selection commands are sent by RS-232 and Volume com-
mands are sent by IR. If some commands but others are not working, check the
wiring type that matches the codes that are not working.
If you are using learning a device manufactured by Philips, Magnavox, or Koss,
consult the SP Controls PXE-DCM Philips Protocol Application Note for additional
programming instructions.
If you are still unable to control your device, please contact SP Controls Technical
Support for further assistance.
XI. Technical Specifications
Package Type
Dimensions
Weight (PCB with bezel and 3
insert modules)
Power Supply
Output Type
Recommended Wire
The PixiePlus is UL listed and CE certified.
Single-Gang Decora™ Mounting
4.130" (h) x 1.745" (w) x .90" (d)
2.5 oz
6VDC, 300mA
IR Emitter/RS-232 (preconfigured, reprogram-
ming RS-232 requires
separately)
CAT5, CAT5e, or CAT6; male-female RS-232
straight serial
X. Troubleshooting cont'd
, sold
22