EPSON Stylus Scan 2500
5.3.3 Initial Ink Charge Operation
There is no ink in the ink path of a spare printhead and printer mechanism
when first installed; therefore, after replacing either of these two parts, you
need to perform an initial ink charge.
1. Enter the Production menu as described in "Using the Service-
Adjustment Program" on pag e116.
2. On the Production menu (Figure 5-6), select Ink Charge. Then click OK
in the dialog box that appears.
It takes approximately 90 seconds for the ink charge
operation to complete.
Adjustment
5.3.4 Bi-D Adjustment
You perform this adjustment to correct differences in printing positions,
which is caused by slippage of printing timing in right and left directions
during the Bi-directional printing. Therefore, you need to perform this
adjustment after performing the following operations.
T
T
T
T
T
1. Enter the Production menu as described in "Using the Service-
Adjustment Program" on page 116.
2. On the Production menu (Figure 5-6), select Bi-d Adj. - Normal. The Bi-
d Adjust dialog box appears.
3. Click OK in the dialog box that appears to print adjustment patterns
with the current settings.
Using the Service-Adjustment Program
Replacing the printer mechanism
Replacing the main board
Replacing the CR motor
Replacing the Carriage Assembly
Replacing the Printhead
Revision A
122