Initial Ink Charge Operation - Epson Stylus SCAN 2000 Service Manual

EPSON Stylus Scan 2500

5.3.3 Initial Ink Charge Operation

There is no ink in the ink path of a spare printhead and printer mechanism when first
installed; therefore, after replacing either of these two parts, you need to perform an initial
ink charge.
1. Enter the Production menu as described in "Using the Service-Adjustment
Program" on page 121.
2. On the Production menu (Figure 5-6), select Ink Charge. Then click OK
in the dialog box that appears.
It takes approximately 90 seconds for the ink charge operation to
complete.
5.3.4 Bi-D Adjustment
You perform this adjustment to correct differences in printing positions, which is caused by
slippage of printing timing in right and left directions during the Bi-directional printing.
Therefore, you need to perform this adjustment after performing the following operations.
n
Replacing the printer mechanism
n
Replacing the main board
n
Replacing the CR motor
n
Replacing the Carriage Assembly
n
Replacing the Printhead
1. Enter the Production menu as described in "Using the Service-Adjustment
Program" on page 121.
2. On the Production menu (Figure 5-6), select Bi-d Adj. - Normal. The Bi-d
Adjust dialog box appears.
Adjustment
3. Click OK in the dialog box that appears to print adjustment patterns with
the current settings.
Using the Service-Adjustment Program
Revision A
127