Removing The Pe Paper Detector Assembly - Epson STYLUS Scan 2500 Service Manual

EPSON Stylus Scan 2500

4.6.7 Removing the PE Paper Detector Assembly

1. Remove the housing. (Refer to Section 4.3.)
2. Release two fixed hooks securing the PE detector assembly from the back
of the frame and remove the PE detector assembly, sliding it upward.
Remove the PE board assembly and PE lever, if necessary.
During assembly, make sure that the tip (sensor part) of
the detector lever is in the hole of paper guide assembly.
Disassembly & Assembly
This side should
be installed on the
PE Board Assembly
Disassembling the Printer Mechanism
After releasing two hooks, remove
the PF paper detector assmebly,
sliding it upward.
PE Holder
frame.
Figure 4-16. Removing the PE Detector Assembly
Revision A
(From back side of
the frame)
PE Lever
Torsion Spring 0.22
108