Epson STYLUS Scan 2500 Service Manual page 112

EPSON Stylus Scan 2500
4.7.1.2 Removing the scanner power supply board
1. Remove the scanner cover and lamp as described above.
2. Remove one screw (CBP 3x8 with flange).
3. Remove one connector CN1.
4. Remove the power supply board.
Disassembly & Assembly
4.7.1.3 Removing the scanner assembly from the scanner
guide shaft
1. Using pliers, remove one spring..
2. Remove two screws (CBS 3x6).
3. Turn the scanner vertical and remove the FFC.
4. Using pliers, remove the carriage belt clip.
5. Slide the left carriage guide frame slightly to the right.
6. While rotating the belt around the pulley, remove the belt from the driven
pulley.
7. While supporting the scanner with one hand, slide the left carriage guide
frame to the left until the carriage guide shaft comes free.
8. Slide the scanner assembly off the carriage guide shaft.
Disassembly of the Scanner Mechanism
3) Remove the FFC.
1) Remove
spring here.
2) Remove two
screws.
Revision A
5) Slide the left
carriage guide frame
to the right to
release the belt.
4) Remove
carriage belt clip.
111