Overview; Precautions For Disassembling The Printer - Epson STYLUS Scan 2500 Service Manual

EPSON Stylus Scan 2500

4.1 Overview

This chapter describes procedures for disassembling the main components of
the EPSON Stylus Scan 2500. Unless otherwise specified, disassembly units
or components can be reassembled by reversing the disassembly procedure.
Therefore, no specific assembly procedures are included in this chapter, but
special points regarding re-assembly are given under the heading "CHECK
POINT". Any adjustments required after disassembling the units are
described under the heading "REQUIRED ADJUSTMENT".
Disassembly & Assembly

4.1.1 Precautions for Disassembling the Printer

See the precautions given under the headings "WARNING" and "CAUTION"
below, before disassembling or assembling the EPSON Stylus Scan 2500.
Disconnect the power cable before disassembling or
assembling the printer.
Wear protective goggles to protect your eyes from
ink. If ink gets in your eye, flush the eye with fresh
water and see a doctor immediately.
If ink comes into contact with your skin, wash it off
with soap and water. If irritation occurs, contact a
physician.
A lithium battery is installed on the MAIN Board of
this printer. Be sure to observe the following
instructions when servicing the battery:
Keep the battery away from any metal or other batteries
so that electrodes of the opposite polarity do not come in
contact with each other.
Do not heat the battery or put it near fire.
Do not solder on any part of the battery. (Doing so may
result in leakage of electrolyte from the battery, burning
or explosion. The leakage may affect other devices close
to the battery.)
Do not charge the battery. (An explosion may be
generated inside the battery, and cause burning or
explosion.)
Do not dismantle the battery. (The gas inside the battery
may hurt your throat. Leakage, burning or explosion may
also be resulted.)
Do not install the battery in the wrong direction. (This
may cause burning or explosion.)
Overview
Revision A
75