Installation
The TERMPWR jumper enables the active termination circuit to receive power
from an external host when installed. Figure 3-4 shows the termination power
circuitry.
The drive has an on-board green 'Busy' LED and a yellow 'Fault' LED.
5 % # 2 K P % Q P P G E V Q T 8 G T U K Q P U
This section describes the SCA-2 (Single Connector Attachment) 80-pin connector
for Maxtor Atlas 10K III drives with the following features:
• SCSI ID
• Spin Up
• Activity LED displays
3-10
Maxtor Atlas 10K III
Termination Power Circuitry