Change Descriptions - Lucent Technologies DEFINITY Guide Manual

Change Descriptions

The following problems are corrected and addressed in DEFINITY Enterprise
Communications Server (ECS), Release 6, Issue 2.1 (02.1.125.1).
1. When an off-net coverage or forwarded call could not find an available
trunk, busy tone was played back to the calling party, effectively ending
the call. Now, the call is redirected back to the original principal whenever
possible.
2. A customer with a BRI terminal that is capable of seeing cause values saw
"Normal Call Clearing" when listening to any announcement or tone when
it timed out or completed. Now, if that user is listening to reorder, busy or
Intercept tone and the tone times out, that user sees a cause value that
represents the reason for the tone, that is¨ "User Busy" or "Call Rejected."
3. Assume that station A called station B, station B conferenced station C,
and station C covered through DCS to a remote station D. After B
dropped, station C displayed its own name. Now, after station B drops, C
displays station A's name and station A displays station C's name.
4. When a bridge of the originating party dropped out of a call that had
routed off-net with call classification on a non-ISDN end-to-end trunk, the
call was torn down. Now, the call is not torn down, but call classification is
terminated, the call is left off-net, and it is not redirected to subsequent
coverage.
5. Station A had a remote coverage point and the station was forwarded to
station B. When a call was placed to station A when station B was active,
the call did not go to the coverage point.
6. When TTI was turned on and a station was call forwarded, a user could
remove the call forwarded station and add a new station with the new
station being forwarded to the destination of the removed station.
7. Removing an EPN cabinet without first turning off TTI caused translation
corruption.
7
Issue 2 May 1998