Epson LX-810 Technical Manual page 119

4.2.4.2 Removal of Printer Mechanism
1. Remove the platen unit and paper guide (refer to Section 4.2.4.1, immediately above).
2. Disconnect the cables from the following connectors on the TAMA board: CN4 (red), CN5 (white),
3. With a screwdriver, push and loosen the six tabs securing the printer mechanism to the lower casing.
For easiest removal, follow the procedure below.
Be sure to push the tabs GENTLY, so as not to damage the lower casing or printer mechanism.
a.
Loosen tabs 1 and 2, and lift the left side of the frame about 1 cm above the lower casing.
b. Loosen tab 3, and raise the left side further, so that it is about 3 cm above the lower casing.
c. Loosen tab 4,5, and 6 and remove the printer mechanism.
WARNING
Figure 4-17. Printer Mechanism Removal
4 - 1 3
REV.-A