4.2.3.2 TA Filter Unit Removal
1. Remove the upper casing (refer to Section 4.2.2.1).
2. Disconnect connector CN9 at the TAMA board. This connector connects the TA
filter unit.
the CB(0) (M3 x 6) screws securing the frame GND wire.
3. Remove
4. Remove the CBB (M3 x 12) screws and CB(0) (M3 x 6) screws securing the filter unit, and then remove
the unit.
' TA Filter
Figure 4-10. TA Filter Unit Removal
4-9