Epson LX-810 Technical Manual page 102

5. Remove the E-ring (6) from the sprocket shaft, then remove sprocket mounting plate R.
6. From the sprocket shaft and the sprocket guide shaft, pull and remove sprocket set R, the paper guide
roller, and sprocket set L. In separating the paper guide roller, pull in the same direction as the side
on which the T-shaped notch is located. (When reassembling, insert from the same side.)
Figure 3-15. Removal of Sprocket Mounting Plate.
Sprocket Shaft
Paper-Guide Roller'
Figure 3-16. Direction of Paper Guide
Sprocket
Mounting Plate R
Roller Removal
3-18
o