Destination Data Writing Operation - Epson Stylus Pro XL Service Manual

Adjustment

4.1.2 Destination Data Writing Operation

The setup value that specifies the printer destination is stored in EEPROM on the C184 MAIN board.
Therefore, this setup value must be written to the EEPROM when the main board or EEPROM chip is
replaced. This function is always selected to finish the program using END operation.
Before writing the destination data writing, set the interface to parallel or auto select.
1. Connect the PC to the target printer using a parallel interface cable and turn the printer on.
2. Load BASIC on the PC, and run the program. You see the following destination select menu.
***** Customer *****
1. EAI, EAI (Latin America), EAL, ESP
2. EDG, EUL, EFS, EIS, EIB, EUL (Northern Europe), EUL (Middle East), EHK
3.
4. JAPAN
5.
6.
7. END
Select Menu ?
3. Input the number for the destination. Then the main menu appears, as shown shown below.
If you enter an incorrect number as the destination selection, printer functions are not
guaranteed.
STYLUS Pro XL+ Program : Rev. X
customer :
1. Head VH input
2. Ink consumption counter reset
3. Head angular & linear adjustment
4. Head position check
10. Change customer & data / END
0. Cleaning
Select Menu ?
4. When the main menu appears, choose "10, Change customer & data / END" by typing 10 and pressing
Enter.
5. The main menu immediately disappears briefly and then the destination select menu appears.
6. Choose "END" by typing 7 to exit the adjustment program.
Settings have not yet been written to the EEPROM. Turn off the printer immediately after the
adjustments.
7. Turn off the printer.
4-4
Stylus Pro XL+ Service Manual
Rev.A