Figure 4-17. Head Gap Adjustment Flowchart - Epson Stylus 1500 Service Manual

Stylus 1500 Service Manual
7. Refer to the pattern and input a value from –12 to 12 to align both black and magenta lines (or to bring F
within 0 0.035 mm), as shown in the following flowchart.
Choose " Head Gap Adj." to enter
the head gap adjustment

Figure 4-17. Head Gap Adjustment Flowchart

8. Press ENTER to exit the setting mode, or press SPACE to continue making settings.
rThe values are not permanently stored in EEPROM until the printer is turned off. Turn off
the printer at once after adjustment.
rPerform the initial ink charge operation using the adjustment program before sending the unit
back to the customer.
9. The menu below appears on the display. To end the program, press 5.
Stylus 1500 <********> Customer Data <********> 95/**/**
( Customer Data Input ) .... 1
( Adjustment
( END
SELECT MENU
n
10. Turn off the printer.
Rev.A
START
Select the resolution
NO
Is the head gap OK ?
YES
Which direction is
the pattern ?
Input +1 value and
ENTER key
Press ENTER key
NO
Are all resolutions
OK ?
YES
Press ENTER key
To main menu
) .... 2
) .... 5
F
Input -1 value and
ENTER key
Adjustments
4-23