Disassembly and Assembly
3.2.13 Front / Rear PE Sensor Removal
1.
Remove the upper housing. (See Section 3.2.1.)
2.
Remove the printer mechanism. (See Section 3.2.2.)
3.
Disconnect the sensor cables from the sensor connectors.
4.
Remove the sensors from the rear paper guide assembly. (Release the hooks on both sides of the
sensors by inserting a screwdriver between the sensors and the rear paper guide assembly as shown in
the figure below.)
Front PE Sensor Cable
Figure 3-30. Removing the Front / Rear PE Sensors
3-30
Rear Paper Guide Assembly
Front PE Sensor Cable
Stylus 1500 Service Manual
Rear PE Sensor Cable
Rear PE Sensor Cable
Hoo k s
Rev.A