Epson Stylus 1500 Service Manual page 113

Stylus 1500 Service Manual
5. Press SPACE and ENTER to enter the adjustment mode. The printer prints out an adjustment pattern,
and the adjustment selection menu appears, as shown below.
Figure 4-5. Black Head Angle Adjustment Pattern
6.
Loosen 2 (CBP(P2) 3
7. Move the angle adjust lever to the back or front so that the vertical lines are aligned continuously (to
bring A within 0 0.02 mm), as shown in the following flowchart.
STA RT
Choose "Black Head Adj. " to enter
the black head angle adjustment.
Print the adjustment
pattern.
Is head angle OK ?
Figure 4-6. Black Head Angle Adjustment Flowchart
8. Press ENTER to exit the setting mode, or press SPACE to continue entering settings.
Rev.A
6) screws securing the CR cover to the carriage unit (see Section 3.2.10).
N O
Y E S
What is the slant
of the angle?
Move the lever
1 step forward.
Push the CR cover (H carriage holder) toward
the back once to eliminate looseness between
the black head and carriage unit.
Is head angle OK ?
Press ENTER key.
To ma in men u
A
Move the lever
1 step backward.
Pre ss SPA CE k ey
N O
Y E S
Adjustments
4-9