Setting The Height Stop Of The Burner - Duerkopp Adler 506 Service Instructions Manual

11.2.2 Setting the Height Stop of the Burner

1 2
–
Place material 1 of the maximum allowable thickness (t = 16 mm)
or a spacer under the clamps.
–
Lower the clamps.
–
Turn the main switch off.
Caution Risk of Injury !
Turn the main switch off.
Set the height stop of the burner only with the main switch turned off.
–
Remove the finger guard after loosening the mounting screws.
The clamping screws 3 are readily accessable.
–
Loose the clamping screws 3 slightly.
–
Pull the height stop 2 downward until it touches the lowered
clamps.
–
Tighten the clamping screws 3.
–
Reattach the finger guard again.
Caution Risk of Injury !
After completing the setting work it is essential that the finger guard be
attached again.
3
37