Epson DFX-8500 Service Manual page 100

DFX-8500
When you remove the connector cover, be careful not to break the tabs.
When you remove the printhead cable holder, be careful not to break the printhead holder latch. Use
a slotted screwdriver if necessary.
Step 1: Open the top cover and remove the ribbon cartridge.
Step 2: Remove the two CBS (M3x8) screws securing the FPC cover to the bottom plate of the printer
mechanism.
Step 3: Disconnect the three printhead cables and a ground cable from the FPC board on the bottom plate.
Note 1. When disconnect the cables, hold the cable close to the connector.
Note 2. When disconnect the cable, hold the connector to prevent it from being pulled off the board.
Note 3. When disconnect the cable, pull it slowly and horizontally to the right, as viewed from the
front side.
Figure 3-9. Ribbon Cartridge Removal
Step 4: Unlock the two head cable cover latches by pressing them with your fingers, then remove the
cover by sliding it to the right. Remove the cable protection sheet, too.
3-10
CAUTION
Figure 3-11. Head Cable Cover Removal
Figure 3-10. Head Cable Removal
Rev. B