DISASSEMBLY AND ASSEMBLY
3.2.6.14 PG Home Sensor Removal
Step 1: Remove the front/rear tractor select lever assembly. (Refer to Section 3.2.6.2.)
Step 2: Remove the E-ring securing the carriage guide shaft gear to the rear carriage guide shaft.
Figure 3-68. Carriage Guide Shaft Gear Removal
Step 3: Disconnect the white, 2-pin, PG home sensor connector from the connector junction board
assembly.
Step 4: Detach the hook securing the PG home sensor and remove the sensor.
Figure 3-69. PG Home Sensor Removal
3-47
Rev. B