Setting The Working Height - DURKOPP ADLER 745-34-2 Installation Instructions Manual

Sewing unit for runstitching of piped flap and welt pocket openings and pocket corners

Hide thumbs Also See for 745-34-2:

Table of Contents

3.3

Setting the working height

The working height can be set between 79 cm and 110 cm

(measured up to the upper edge of the table top).

The sewing unit is set to the lowest working height of 79 cm by the

manufacturer.

ATTENTION: Danger of breakage !

When loosening the securing screws.

The sewing unit may overturn when the tubular feet of the frame are

pulled out.

Set the height of the sewing unit by pulling equally the tubular feet of

the frame.

–

Loosen the nut 1 (4x) and the shoulder bolts 2 (4x) (clamping of the

front tubular foot).

–

Loosen screws 3 (4x) (clamping of the rear tubular foot).

–

Set the table top to the desired height to be flush.

–

To avoid a tilting, pull out / push in the tubular feet uniformly on

both side.

–

Tighten the shoulder bolts 2 and the screws 3.

–

If you want to set the foot pedal afterwards, please do not tighten

the nut 1 yet. Otherwise it can also be tightened.

Table of Contents