Eclipse AVN5435 Installation Manual page 13

System connection e
System connection e
•
Never cut the insulation on the power cable or use it to power any other equipment. If the rated current
capacity of the power cable is exceeded, fire and electric shocks may result.
•
The cables should be secured with tape or similar item so it will not cause an obstruction while driving.
If they get wound around components such as the steering wheel, shifting lever or brake pedal,
accidents may result.
Tip
• Install and connect all of the peripheral units before connecting them to the main unit.
• Do not remove the caps of pin jacks unless in use.
• Be sure to wrap the connection cables with plastic tape to insulate them.
MAIN UNIT
1
10P
FRONT
SPEAKERS
POWER CONNECTOR CABLE
(Supplied with CD changer)
TO BATTERY+12V
(Permanent Supply)
xample
xample
4P
6P
TO GROUND
INTERCONNECTING
2
CABLE
REAR
(Power and front
SPEAKERS
speaker connector)
CH3083
(sold separately)
13P
2P
TO GROUND
- 13 -
1P
FRONT
REAR
NON FADER
(remove covers when using external amplifier)
TO MONITOR
6P
INTERCONNECTING CABLE
3
(Rear speaker connector)
BEC104
(sold separately)
GPS ANTENNA
10
INTERCONNECTING CABLE
4
(Video input connector)
FROM EXTERNAL VIDEO EQUIPMENT
TO STEERING REMOTE
CONTROL
ANTENNA EXTENSION CABLE
5
Be sure to use when connecting the
radio antenna to the vehicle.
ANTENNA
PLUG
13P
DIN CABLE
(Supplied with CD changer)