Eclipse AVN5435 Installation Manual page 11

- An example for connecting the parking brake signal -
1
Use a splicing connector to connect the parking
brake signal cable (red/white) coming from the
main unit to the parking brake signal cable of the
vehicle.
2
Route the parking brake signal cable to the main
unit.
Hand-operated
Parking brake
- An example for connecting the reverse signal cable -
Tip
• Be sure to connect the reverse signal cable. If it is
not connected, the vehicle position may be
incorrect when the vehicle is reversed.
• Use a circuit tester to confirm that a sensing
voltage of 6 V or higher is generated when the
vehicle is reversed.
1
Use a splicing connector to connect the reverse
signal cable (green) coming from the main unit to
the reverse signal cable of the vehicle.
2
Route the reverse signal cable to the main unit .
Parking brake
Signal Cable
Foot-operated
Parking brake
Position to attach
a splicing connector
Parking brake
signal cable
Position to attach
a splicing connector
Reverse signal cable
- 11 -
Reverse lamp
Reverse signal cable