Table of Contents
Advertisement
3.
Installing the machine
3.1
Adjusting the working height
3.2
Attaching the yarn stand
6
4
The working height is continuously adjustable between 85 and 120 cm
(measured to the upper edge of the table plate).
–
Undo locking screws 1 and 2 on both sides of the stand.
–
Adjust the table of the machine to the required working height.
–
Tighten locking screws 1 and 2.
–
Insert the reel stand 3 in the hole in the table plate and secure it
with the nuts and washers.
–
Fit and align the yarn-reel bracket 5 and unwinding arm 3 as
4
shown in the illustration.
NB: the yarn-reel holder and the unwinding arm must be vertically
in line.
3
–
Depending on the type of yarn reel the centring piece 6 must be
set as shown in the above illustration. Incorrect settings may lead
to faults in operation.
5
1
2
3
6
Advertisement
Table of Contents
