Completing The Table Plate - Duerkopp Adler 531 Instruction Manual

3.3 Completing the table plate

6
6
5 4 3
–
Put the table plate upside down on a work surface.
–
Screw the main switch 6 on the left onto the bottom of the table
plate.
–
Screw the cable channel 5 behind the main switch 6.
–
Screw the cable channel 2 on the left next to the grommet.
–
Put the connection cable 4 into the cable channel.
–
Fix the connection cable 4 with the strain relief 3.
–
Put the control box 7 onto the bottom of the table plate and turn it
so that the connection side with the four sockets points to the left
(in the direction of the thread stand pipe).
–
Screw the control box onto the punched side on the bottom of the
table plate with four screws.
2 1
7