Assembling The Stand; Assembling The Stand Parts; Completing The Table Top And Fitting It To The Stand; Machines With No Edge Cutter - Duerkopp Adler 275 Instruction Manual

3. Assembling the stand

3.1 Assembling the stand parts

–
Assemble the frame components as shown in the illustration.
–
Fit the four enclosed feet 6 to the frame.
–
Slightly loosen screws 5 on both sides of the cross-brace 7 and make sure the
frame is firm and stable.
All four of the frame supports must be firmly on the ground.
–
Retighten screws 5.
–
Screw the oilcan holder 8 onto the left-hand upright of the frame.

3.2 Completing the table top and fitting it to the stand

3.2.1 Machines with no edge cutter

(classes 275-140332, 275-140342, 275-142342)
–
Fit the top support 15 into the hole in the table plate.
–
Fit the rubber rests 14 for the upper part of the machine into the recesses in the
table plate 12.
–
Fit the rest plug 13 and push on the pressure springs.
–
Screw on the drawer 11 with its brackets under the left-hand side of the table plate.
–
Screw on the cable conduit 10 under the back of the table plate.
–
Mark the positions of the screw connections of the oil collector 2 and attach it under
the table-plate opening with wood screws.
–
Attach the table plate 12 to the frame with wood screws (B8 x 35).
Its position on the frame can be seen from the dimensions in the sketch.
–
Fit the reel stand 1 into the hole in the table plate and attach with nuts and
washers.
Fit and align the yarn-reel holder and thread-guide arm.
The yarn-reel holder and thread-guide arm must be vertically aligned.
GB
9