8. To install a new hard disk drive into the bracket, flex the bracket and align pin
4
on the bracket with the corresponding holes in the hard disk drive.
Figure 22. Installing the hard disk drive into the bracket
Important: Do not touch the circuit board on the bottom of the hard disk drive.
9. Connect the signal cable and the power cable to the new hard disk drive.
10. Insert the two retaining clips
chassis, and then pivot the hard disk drive and bracket downwards until the hard disk drive bracket
snaps into position.
Figure 23. Installing the hard disk drive
11. Go to "Completing the parts replacement" on page 93.
1
of the hard disk drive bracket into the corresponding holes in the
1
, pin
.
Chapter 8
Replacing FRUs (Machine type: 7536)
2
, pin
3
, and pin
85